Power Press Machine for Qatar
National Cutting Tools builds mechanical C-frame and H-frame power presses from roughly 20 to 150 tonnes for blanking, piercing and cup forming at its works in Ludhiana, Punjab, and ships them to Doha, Al Wakrah, Mesaieed, Ras Laffan and Lusail through Hamad Port, Doha. The machines produce scaffold cups, base plates, brackets, gussets and cleats, and are built to the geometry and tolerances called up by EN 692 for mechanical press safety and IS 5062 for the frame. Every consignment for Qatar is built for 415V 50 Hz with Siemens or Schneider protection gear.
Where the demand comes from
Cup and plate pressing capacity for Qatari scaffold manufacture follows welding capacity, and press guarding documentation is part of the QGOSM submittal pack rather than an afterthought.
Delivered to: Doha, Al Wakrah, Al Khor, Mesaieed, Ras Laffan, Lusail, Umm Salal
Power Press Machine available for Qatar
C Frame Power Press
- Type: Power Press Machine
- Press Ram Material: Alloy Steel
- Press Capacity: 10 Ton – 200 Ton
Pillar Type Power Press
- Voltage: 440V
- Automatic Grade: Automatic
- Power Source: Hydraulic
Friction Screw Press
- Feature: Specification
- Press Capacity: 100 – 1000 Tons (model dependent)
- Type: Friction Drive / Screw Type
Electrical build
Supply: 415V, 3-phase, 50 Hz. Built for 415V 50 Hz with Siemens or Schneider protection gear.
Shipping & crating
Press frames are dense: a 100 tonne C-frame is typically over-dimension for a standard container and moves as flat rack or break-bulk, which changes the freight quotation materially. Hamad Port receives direct and Jebel Ali-transhipped sailings from Mundra and Nhava Sheva in 6 to 9 days, discharging at Hamad Port, Doha (QAHMD). Machines are crated to ISPM-15 heat-treated standard with desiccant and a vapour barrier, and the packing list, commercial invoice and chamber-attested Certificate of Origin travel with the consignment.
Standards & import documentation
Machines in this class normally clear customs under HS heading 8462.49. The press is run off on the buyer's own die to prove shut height, and the guarding and two-hand control are set to the importing country's inspection requirement. Import clearance in Qatar runs on Qatar General Organisation for Standards and Metrology (QGOSM) requirements, with a legalised Certificate of Origin and manufacturer test certificate per shipment. The works issues the manufacturer test certificate, electrical schematic and material test report with every machine, so the buyer's submittal pack is complete on arrival rather than assembled afterwards.
| Conformity | Qatar General Organisation for Standards and Metrology (QGOSM) requirements; legalised Certificate of Origin and manufacturer test certificate issued with each consignment. |
| Tariff headings | Typical headings: 8515.31 (arc/MIG welding machines), 8459.70 (threading and tapping machines), 8462.29 (press brakes and forming presses), 8461.50 (sawing machines). |
| Port (UN/LOCODE) | Hamad Port, Doha (QAHMD) |
| Incoterms offered | EXW Ludhiana, FOB Mundra / Nhava Sheva, CIF Hamad Port |
Spares & after-sales support
Wear parts for this class are clutch and brake linings, flywheel bearings, slide gibs and the overload protection discs. Qatari plant approval leans on documentation: contractors want the electrical schematic, the motor test certificate and the material test report in the submittal pack. Those are issued as a matter of course, not on request. Spare-part orders are quoted against the machine serial number.